Cart 0

Stripflock Pro

Soft, suede-like texture is StripFlock Pro's signature look, offering an array of opaque and intense colors that mimic the feel of velvety fabric. Layer underneath or on top of this heat transfer vinyl for unlimited possibilities! When you're looking for your design to stand out, Siser's StripFlock is a great touch.

Specification:

    • Cotton, Polyester, Cotton/Poly Blends, Leather
    • Suede-like finish
    • Cold peel
    • 16.1 Mils (410 microns) thick
    • Can be layered
    • PVC composition
    • Pressure sensitive backing
    • 1 year shelf life
    • Siser StripFlock is a heat transfer vinyl material meant for use with a vinyl cutter. This is not a printable vinyl. Do not attempt to run it through a printer.

Cutter Settings

Cricut:

  • Blade: Standard
  • Setting: Iron-on+

Silhouette Cameo:

  • Blade: Standard, 4
  • Material: Heat Transfer, Flocked
  • Speed: 5
  • Force: 6

Scan N Cut:

  • Blade: Standard, 4
  • Cut Speed: 1
  • Cut Pressure: 2

Roland GS/GX-24:

  • Blade: 45°
  • Gram Force: 80-120
  • Offset: .250
  • Speed: 30 cm/s

Graphtec:

  • Blade: 45°
  • Gram Force: 10
  • Tool: CB09U+0
  • Speed: 30 cm/s

 

Application Instructions

Heat Press (Strongly Recommended)

  • Cut in reverse
  • Weed excess material
  • Preheat garment for 2-3 seconds
  • Apply design at 311°F/155°C
  • Use medium pressure for 10-15 seconds
  • Peel carrier hot

Home Iron

  • Cut in reverse
  • Weed excess material
  • Set iron dial between Cotton and Linen
  • Cover design with Kraft paper or non-stick cover sheet
  • Place on flat, hard surface (ironing board not recommended)
  • Press iron with medium/firm pressure (do not slide iron)
  • Press each section of design for 15 seconds
  • If areas of design lift after application, replace cover sheet and re-press for 10 seconds
  • Peel carrier hot
StripFlock Pro 15"

StripFlock Pro 15"